Flanged Elbow – Isometric

Note: This is a bonus assignment, this may only be done when all due work is completed!!

Draw in Isometric from the Top and Front Views - see notes on Isometric

To draw the circles you will draw ELLIPSES using the Isometric feature as follows:

Select Ellipse and then enter “I” for Isometric then specify the middle of the ellipse (center of box) and the edge of the ellipse (the midpoint of a box side).

Make sure you are on the proper Isometric Plane Mode – Use F5 to change between modes.

The arcs for the pipe portion are somewhat approximate

Do NOT dimension.