Hints:

Draw in Isometric from the Top and Front Views

75cc02.jpg

Right click on the ISODRAFT button at the bottom and change the settings as follows:

If you are unable to find the ISODRAFT button. You can type the following command in the command like to activate the ISODRAFT feature.

Command: SNAPSTYL <enter>

Enter a new value for SNAPSPTYL <0>: 1 <enter>

To return to grid snap style type:

Command: SNAPSTYL <enter>

Enter a new value for SNAPSPTYL <1>: 0 <enter>

 

Draw the 75mm cube first along with the center lines.

To draw the circles you will draw ELLIPSES using the Isometric feature as follows:

  • Select Ellipse – Axis, End – and then enter “I” for Isometric then specify the middle of the ellipse (center of box) and the edge of the ellipse (the midpoint of a box side).
  • Make sure you are on the proper Isometric Plane Mode  (cursor should line up to center lines) – Use F5 to change between modes.

Do NOT dimension.